Siemens WT48XEH9GB, Инструкция по установке и эксплуатации, Страница: 30 / 76

en
Overview of programmes
30
0
Settings
Program setting Function
Note: Not all settings can be activated in every program. The activated settings are displayed on the but-
tons or on the display. You can change or deactivate the activated settings by repeatedly pressing on the
relevant buttons.
Remote Start
}
Pressing Remote Start
}
allows you to start the appliance remotely via the
Home Connect app or to call up the Home Connect settings.
Notes
■
Please observe the instructions for the ambient temperatures
~
Page 72 .
■
Remote start can only be activated if the appliance door is closed and the
appliance is connected to your home network.
■
Remote start is deactivated for safety reasons in the following circum-
stances:
■
Open the door,
■
Power failure,
■
Press Start/Reload on the appliance,
■
Briefly press Remote Start again,
■
Press
#
to switch off the appliance.
Drying Aim : The dryness level defines how damp or dry the laundry is after the pro-
gramme ends.
If you have set a dryness level, this is retained even after the appliance has
been switched off for the relevant programme. Exception: The settings are
not saved for Cottons.
¾
(Cupboard dry extra) Multi-layered, thick laundry that does not dry readily.
»
(Cupboard dry) Normal, single-layered laundry.
Ø
(Iron dry) Normal, single-layered laundry that still needs to be damp after drying and is
suitable for ironing or hanging up.
Less Ironing The drum moves the laundry at regular intervals after drying to prevent creas-
ing. You can activate or deactivate the automatic Anti-Crease function for the
indicated duration in minutes.
Ready In Before starting the programme, you can delay the time at which the pro-
gramme ends by up to 24 hours using
c
and
b
.
The set time in hours, e.g. 8 h, is shown in the display and counts down until
the programme starts. Once the programme has started, the programme
duration is displayed.
Note: Observe the information about the ambient temperatures
~
Page 72 .
ü
The drying time for timed programmes can be extended in 10-minute
increments using
c
and
b
.