Home Connect
en
39
Notes
■
If the smart energy system (energy
manager) does not start your
appliance, the programme will still
be started before the set time period
ends.
The programme ends when the time
period ends.
■
For safety reasons,
Remote Start
and, in turn,
Flex start
are
deactivated in the following
circumstances:
– Press Start/Reload
‹
.
– Open the door.
– Press
#
to switch off the
appliance.
– Power failure.
If the
Flex start
function is
deactivated, the
M
Finish
in
B
N
(Finished in) remains active.
Adding more laundry or removing
laundry:
Note:
If the
Flex start
function has
already been activated but the
programme has not yet started, you will
still be able to load more laundry or
remove some from the drum.
1.
Press
Start/Reload
‹
.
2.
Open the door.
3.
Add or remove laundry.
4.
Close the appliance door.
5.
Press
Start/Reload
‹
.
6.
Press
Remote Start
}
.
The
FlexStart
function has now been
activated and the appliance will wait to
be remotely started by the smart energy
system (Energy manager).
Intelligent program
recommendation
After you have washed your laundry in
the washing machine, the dryer will
recommend a suitable program for
drying your laundry.
The expected duration of the
recommended program is determined
based on the washing program you just
used.
To determine the best drying program
to use, your appliances must transmit
and receive information.
Therefore please note the following:
■
Before the data can be transmitted,
the washing program must run
through to the end.
■
The washing machine must be
Home Connect-capable.
■
The washing machine and dryer
must be connected to your home
network and registered in your
Home Connect app.
1.
Switch on the appliance.
2.
Set the program to
intelligentDry
È
.
The analysis starts and an animation
appears in the display.
3.
To cancel the analysis, set a different
program or switch the appliance off.
Once the right programme is found, the
animation stops, the LED for the
recommended programme lights up
permanently and programme
information is shown in the display.
4.
Press
Start/Reload
‹
.
Note:
If a suitable program cannot be
found, an audible signal will sound and
{ {{
will appear on the display.
