Cleaning and maintenance
en
43
4.
Carefully unscrew the pump cover;
residual water may leak out.
Clean the interior, pump cover
thread and pump housing. The
impeller in the drain pump must be
able to rotate.
5.
Refit and screw on the pump cover.
The handle must be in a vertical
position.
6.
Close the service flap.
Note:
To prevent unused detergent
from flowing straight into the drain
during the next wash: Pour 1 litre of
water into dispenser II and start the
Spin
programme.
The drain hose at the siphon
is blocked
1.
Turn the programme selector to
Û
(Off)
. Pull out the mains plug.
2.
Loosen the hose clamp. Carefully
remove the drain hose; residual
water may leak out.
3.
Clean the drain hose and siphon
connecting piece.
4.
Re-attach the drain hose and secure
the connection point using the hose
clamp.
Filter in the water supply is
blocked
Release water pressure in the supply
hose:
1.
Turn off the water tap.
2.
Select any programme (except
Rinse and Spin
programmes).
3.
Select the
I
Start/Reload
button.
Allow the programme to run for
approx. 40 seconds.
4.
Turn the programme selector to
Û
(Off)
.
5.
Pull out the mains plug.
