Programme default settings
en
23
Spin speed
(Centrifuga)
Depending on what stage the
programme is in, you can change the
spin speed (in rpm; revolutions per
minute) before and during the
programme.
The maximum speed that can be set
depends on the model and programme
that has been selected.
Setting 0
: No spin cycles, the water is
only drained. The laundry stays wet
inside the drum, e.g. for items that
should not be spun.
Finished in
(Fine fra)
The programme duration is shown after
selecting the programme.
Before starting the programme
, you
can preselect the programme end in
hourly increments (h = hour) up to a
maximum of 24 hours.
After starting the programme
, the
selected number of hours
e.g. 8 h
is
shown on the display panel and counts
down until the wash programme starts.
The duration of the programme is then
displayed.
Note:
The programme duration is
automatically adjusted when the
programme is running. Changes to the
programme default settings or
programme settings, options, foam
detection function, unbalanced load
detection, the load or soiling may also
change the programme duration.
After starting the programme
, you can
change the preselected number of
hours as follows:
1.
Press the
Ü
button.
2.
Use the
Finished in
button to
change the number of hours.
3.
Press the
Ü
button.
After starting the programme
, while the
programme is running, you can add or
remove laundry if necessary.
