Siemens WM14Y790GC, Инструкция по эксплуатации и руководство по установке

Страница: 55 / 60

55
Before the 1st washing
The washing machine was inspected thoroughly before leaving
the factory. To remove any water left over from testing
procedures, the first washing cycle should be carried out
without
laundry in the machine.
²
The washing machine must have been installed and connected
properly. See chapter Installing
~
Page 53
1.
Check the machine.
²
Never switch on a damaged machine. Inform your customer
service.
~
Page 42
2.
Remove protective film from the fascia.
3.
Insert mains plug.
4.
Turn the tap on.
5.
Switch on the appliance.
6.
Close the washing machine door. Do not load any washing.
7.
Select the
Cottons
programme.
8.
Select the temperature
90 °C
.
9.
Open the detergent drawer.
10.
Pour approx. 1 litre of water (1¾ pt) into dispenser
II
.
11.
Add standard detergent to dispenser
II
according
to manufacturer’s instructions for light soiling.
²
To prevent frothing, use only half the recommended amount
of detergent. Do not use any standard or mild detergents.
12.
Close the detergent drawer.
13.
Select
Start
/Reload
Ü
.
14.
When the programme ends, switch off the appliance.
Your washing machine is now ready for use.