
operation
en
35
13.3 Adjusting the pro-
gramme settings
Requirement:
A programme has
been set.
→
"Setting a programme", Page 34
▶
Adjust the programme settings.
→
Observe the information about op-
erating logic →
.
Notes
¡
The programme settings are not
saved permanently for the pro-
gramme.
¡
The setting is saved if you activate
or deactivate the intelligent dosing
system.
Adjusting additional programme
settings
1.
Press
možnosti
to call up addi-
tional programme settings.
2.
Select the programme settings.
3.
Press
možnosti
to call up the
main menu.
13.4 Saving the programme
settings
1.
Set the
oblíbený program
pro-
gramme.
2.
Press
to call up the sub-
menu.
3.
Select a programme.
4.
Press
meny
to call up the main
menu.
5.
Adjust the programme settings if
required.
a
The programme is saved.
13.5 Loading laundry
Note:
To prevent creasing, take note
of the maximum load for the
→
Requirement:
The laundry is pre-
pared.
→
1.
Open the door.
Make sure that the drum is empty.
2.
Place the laundry in the drum.
3.
Close the door.
Ensure that there is no laundry
trapped in the door.
13.6 Adding detergent and
care product
For programmes in which intelligent
dosing is not possible or desirable,
you can add detergent manually.
Note:
The dosing recommendation is
aimed at the maximum load for the
programme.
Tip:
In addition to intelligent dosing,
you can also add additional care
product for laundry, e.g. stain re-
mover, starch or bleach, to the
manual dosing compartment. Do not
add any additional detergent to the
manual dosing compartment to avoid
overdosage and/or foaming.
Note:
Observe the information about
1.
Pull out the detergent drawer.
2.
Pour in detergent.
→
3.
If required, add the care product.
4.
Push in the detergent drawer.
13.7 Starting the programme
Note:
If you want to change the time
until the programme ends, set the
"Ready in" time first.
▶
Press
start/doplnění
.