Faults and what to do about them
en
41
Filter in the water supply is
blocked
First, reduce the water pressure in the
supply hose:
1.
Turn off the tap.
2.
Select any program (except Spin
0
).
3.
Press the Start/Reload button. Allow
the program to run for approximately
40 seconds.
4.
Turn the program selector to off
position.
5.
Pull out the mains plug.
6.
Clean the filter on the tap:
Disconnect the hose from the tap.
Clean the filter with a small brush.
7.
For standard and Aqua-Secure
models, clean the filter on the rear of
the appliance:
Remove the hose from the rear of
the appliance.
Use pliers to remove the filter and
then clean it.
8.
Insert the filter, connect the hose and
check for leaks.
3
Faults and what to do
about them
Faults and what to do about them
Emergency release
(depending on the model)
e.g. in the event of a power outage
Note:
The programme will continue
running when the power supply has
been restored.
:
Warning
Risk of scalding!
When you are washing at high
temperatures, there is a risk of scalding
if you come into contact with detergent
solution and laundry.
If possible, leave it to cool down.
:
Warning
Risk of injury!
You may injure your hands if you reach
into the drum while it is turning.
Do not reach into the drum when it is
turning. Wait until the drum has stopped
turning.
Caution!
Water damage
Any escaping water may cause water
damage. Do not open the washing
machine door if water can be seen
through the glass.
If the laundry has to be removed, the
washing machine door can be opened
as follows:
1.
Switch off the appliance.
2.
Disconnect the mains plug.
3.
Drain the water.
4.
Pull the emergency release
downwards with a tool and release.
The washing machine door can now
be opened.
