en
Faults and what to do about them.
40
2.
Drain the water
.
3.
Use a tool to pull the emergency
release downwards and then
release.
The washing machine door can then
be opened.
Information on the display panel
Indicator
Cause/remedy
®
off
The door is unlocked at the end of the programme or when paused, laundry can be
added/removed
®
is lit up
■
During the programme. Door locked.
■
Paused: Temperature too high. Wait until the temperature drops.
■
Paused: Spin speed too high. Wait until the drum comes to a halt.
■
Paused: Water level too high. It is not possible to add laundry. Touch
‹
to con-
tinue the programme.
®
flashes
■
Slowly: The door cannot currently be locked or unlocked. Waiting time
required.
■
Quickly: Close the door because water can flow out from the laundry.
®
and the
sensoFresh
î
indic
ator light flash
The door cannot be opened due to programme-related technical reasons.
When the lights go off, the door can be opened.
‹
off
At the end of the programme, while the door is open
‹
is lit up
After the programme has started
‹
is flashing
Before the programme starts, paused
|
is lit up
Water pressure too low, may increase the length of the programme.
|
is flashing
No water supply:
■
Turn the tap on fully,
■
The supply hose is kinked/trapped,
■
Clean the filter if necessary.
w
3 sec is lit up
The childproof lock is activated – deactivate it.
w
3 sec is flashing The childproof lock is activated – the programme selector has been turned or the
control panel touched.
ä
is flashing
Run the
ä
Drum Clean
î
90 °C
programme or a 60 °C programme to clean and
care for the drum and the outer tub.
Notes
■
Run the programme without laundry.
■
Use standard washing powder or a detergent that contains bleach. To prevent
foaming, only use half the amount of detergent recommended by the detergent
manufacturer. Do not use detergents intended for woollens or delicates.
■
Switching the information signal on/off