Siemens WM14T660ME, Инструкция по эксплуатации и руководство по установке

Страница: 43 / 44

Positioning and connecting
en
43
Notes
■
The washing machine
must be
correctlyinstalled
and
connected
.
(from
~
Page 38 ).
■
Never use a damaged machine.
Inform your customer services.
Preparatory work:
1.
Check the machine.
2.
Fill the
ß
and
i
/
ß
dispensers.
~
Page 24
3.
Remove the protective film from the
control panel.
4.
Connect the mains plug.
5.
Turn the tap on.
Run the programme without laundry.
1.
Switch on the appliance.
2.
Close the door (do not load any
laundry).
3.
Set the
Drum Clean 90 °C
programme.
4.
Open the detergent drawer.
5.
Pour approx. 1 litre of water into
compartment
É È
.
6.
Pour standard detergent into
compartment
É È
.
Note: .
To prevent foaming, only use
half the amount of detergent
recommended by the detergent
manufacturer. Do not use detergent
designed for woollens or delicates.
7.
Close the detergent drawer.
8.
Press the
Ü
button.
9.
Switch off the appliance at the end of
the programme.
Your washing machine is now ready to
use.
Transportation
E.g. when moving house
Caution!
Risk of damage to the appliance
caused by detergent/fabric softener
leaking from the dispensers.
Leaking detergent/fabric softener can
prevent the appliance from working
correctly, e.g. due to damage to the
electronics.
Empty the dispensers before
transporting the appliance.
Preparatory work:
1.
Turn off the tap.
2.
Reduce the water pressure in the
supply hose:
~
Page 31 ; cleaning
and maintenance – filter in the water
supply clogged
3.
Disconnect the washing machine
from the mains.
4.
Drain any residual water:
~
Page 30 ; cleaning and
maintenance – drain pump blocked,
emergency draining
5.
Remove the hoses.
6.
Empty the dispensers.
~
Page 29
Installing the transport braces:
1.
Remove the covers and keep them
in a safe place.
Use a screwdriver if necessary.
2.
Insert all four sleeves.
Clip the mains cable securely in the
holders. Insert and tighten the
screws.
Before switching on the appliance
again:
Notes
■
Always
remove the transport braces.
■
To prevent unused detergent from
flowing straight into the drain during
the next wash: Pour approx. 1 litre of
water into compartment
É È
and
start the
Empty
programme.