en
Faults and what to do about them.
26
Information on the display
panel
Faults and what to do about
them.
Display
Cause/remedy
YES
The washing machine door is unlocked. It is possible to add laundry.
NO
■
Temperature too high. Wait until the temperature drops.
■
Water level too high. Not possible to add laundry. Close the washing machine
door immediately, if necessary. Press
Start
!
to continue the programme.
v
flashes
■
Laundry may be jammed. Open and close the washing machine door again and
press
Start
!
.
■
If necessary, press the washing machine door or remove some laundry and
then press again.
■
If necessary, switch the appliance off and on again; set the programme and
make your individual settings; start the programme.
E:17
■
Turn on the tap to the full,
■
Supply hose kinked/trapped,
■
Water pressure too low. Clean the filter.
E:18
■
Detergent solution pump blocked. Clean the detergent solution pump.
■
Drainage hose/waste pipe blocked. Clean the drainage hose at the siphon.
E:23
Water in the base tub, appliance leaking. Turn off the tap. Call the after-sales ser-
vice.
w
Childproof lock activated; deactivate.
¼
flashes
Too much foam detected, a rinse cycle has been switched on.
:
Mains voltage is too low.
.
Undervoltage in the wash programme.
The programme is extended.
Other displays
Switch off the appliance, wait for five seconds and then switch it on again. If the indi-
cator appears again, call the after-sales service.
Faults
Cause/remedial action
Water is leaking out.
■
Attach/replace the drainage hose correctly.
■
Tighten the screw connection of the supply hose.
No water supply.
Detergent not dispensed.
■
Start
/Reload
!
not pressed?
■
Tap not turned on?
■
Filter blocked? Clean the filter.
■
Supply hose kinked or trapped?
