en
Faults and what to do about them.
26
Information on the display panel
Faults and what to do about them.
Display
Cause/remedial action
YES
The washing machine door is unlocked. It is possible to add laundry.
NO
■
Temperature too high. Wait until the temperature drops.
■
Water level too high. Not possible to add laundry. Close the washing machine
door immediately, if necessary. Select
Start
/Reload to continue the pro-
gramme.
v
flashes
■
Laundry may become trapped. Open and close the washing machine door
again and select
Start
/Reload.
■
If necessary, push the washing machine door closed or remove the laundry and
push it closed again.
■
If necessary, switch the appliance off and on again; set the programme and
make your individual settings; start the programme.
E:17
■
Turn the water tap on fully,
■
supply hose kinked or trapped,
■
water pressure too low. Clean the filter.
E:18
■
Detergent solution pump blocked. Clean the detergent solution pump.
■
Drain hose/waste pipe blocked. Clean the drain hose on the siphon.
E:23
Water in the base tub, appliance leaking. Turn off the tap. Call the after-sales ser-
vice.
w
Childproof lock activated; deactivate it.
¼
flashes
Too much foam detected, a rinse cycle has been switched on
Other displays
Switch off the appliance, wait for five seconds and switch it back on again. If the
indicator appears again, call the after-sales service
Faults
Cause/remedial action
Water is leaking out.
■
Attach/replace the drainage hose correctly.
■
Tighten the screw connection of the supply hose.
No water supply.
Detergent is not dis-
pensed.
■
Start
/Reload not selected?
■
Tap not turned on?
■
Filter blocked? Clean the filter.
■
Supply hose kinked or trapped?
Washing machine door
cannot be opened.
■
Safety function active. Programme stopped?
■
– – –
0
(Rinse hold = without final spin) selected?
■
Can be opened by emergency release only?
Programme does not
start.
■
Start
/Reload or
"Ready in"
time selected?
■
Washing machine door closed?
■
w
Childproof lock activated? Deactivate it.
