15
Washing programmes*
*depends on the model
Q
Shirts/Business
Non-iron shirts made of cotton, linen, synthetic fibres or blended fabrics.
Gentle spin only, hang up dripping wet.
J
Night wash
Particularly quiet wash programme with a reduced final spin.
Sleep mode. Once the programme has finished, the display goes out, but
can be reactivated by pressing any button.
Drying programmes
ˆ
Intensive Dry
Intensive drying for
a
(robust fabrics), at 90°C.
‰
Low Heat Dry
Gentle drying for
`
(easy-care fabrics), 60°C.
Special programmes
7
Fluff Clean
The drum must be empty.
This programme is designed to clean the drying cycle of any fluff
deposits. The washer-dryer uses the flashing symbol
7
(
Fluff removal
cycle
) in the display panel to show that this programme must be run. The
electronic cycle counter is then automatically reset. The
7
(
Fluff removal
cycle
) symbol goes out after the programme starts.
To run the
Fluff removal cycle
, proceed as follows:
Make sure that the drum is completely empty and close the door.
Set the programme selector to
7
(Fluff-removal cycle)
.
Press the
!
(
Start/
Pause) button.
The
7
(Fluff-removal cycle)
programme can also be run at any time
without prompting by the appliance.
Rinse
'
+ Spin
0
:
An additional rinse cycle with a final spin. If the laundry is to be removed
dripping wet, set the Spin speed to
$
(Rinse hold)
before Programme
Empty
+
+ Spin
0
:
Drain the rinsing water following a programme with
$
Turn the programme selector to
Empty
+
+ Spin
0
.
Set the Spin speed to
$
(Rinse hold)
.
Press the
!
(
Start/
Pause) button.
or
Drain
and
spin at the desired spin speed:
Turn the programme selector to
Empty
+
+ Spin
0
.
Press the
0
Spin
button repeatedly until the desired spin speed is set.
Press the
!
(
Start/
Pause) button.
