Siemens TIM 1531 IRC, Руководство по эксплуатации, Страница: 127 / 338

Configuration
4.23 Messages
TIM 1531 IRC
Operating Instructions, 02/2018, C79000-G8976-C468-02
127
4.22.10 Partner stations
Enabling the partner for the ST7 data point
Enable all partners to which a telecontrol connection was configured and with which the
selected data point will exchange data. To do this select the relevant " " check box.
You can configure or change the partners in the overview table or in the "Partner stations"
tab of the module. The data will be adopted at the other point.
4.23 Messages
Configuring e-mails
If important events occur, the TIM can send e-mails to a communications partner.
You configure the e-mail in STEP 7 in the editor for the data point and message
configuration. You can find this using the project tree:
Project > Directory of the relevant TIM
For the view in STEP 7, refer to the section Data point configuration (Page 104).
Requirements and necessary information
Remember the following requirements in the configuration for the transfer of messages:
● Enabling telecontrol communication ("Communication types") parameter group
● SMS: Configuration of the SMSC in the "SMSC" parameter group
● E-mails: Configuration of the "E-mail configuration" parameter group
To do this, you require the following information:
–
Access data of the SMTP server: Address, port number, user name, password
– TIM's own e-mail address
– Email address of the recipient
"Message parameter"
Here you configure the recipient, the subject and the text of the message.
"Trigger"
In the "Trigger" parameter group you configure triggering for sending the message and other
parameters.
● E-mail trigger / SMS trigger
Specifies the event for which the sending of the message is triggered.
–
Use PLC tag
For the trigger signal to send the message, the edge change (0
→ 1) of the trigger bit
"PLC tag for trigger" is evaluated that is set by the user program. When necessary, a