Rinse SystemNL
1.
Press and lift the tab on the lid of
the rinse aid reservoir .
2.
Approx. 3 seconds on
to access the basic settings.
Busy-
aThe display shows Hxx. aThe
display shows
reflected
to give.
2
3.
Just as often on
until the display shows the
factory-set value r04.
to press
4.
Just as often on
press until
the desired amount of rinse aid
has been set.
1
– A low setting adds less rinse aid
during the wash cycle, reducing
the streaks on the dishes.
– A higher setting adds more rinse
aid during the wash cycle,
reducing water spots and
improving drying results.
2.
Top up the rinse aid up to the max
mark.
max
5.
To save the settings, press . for
about 3 seconds
to press.
Switch off rinse system
3.
If rinse aid has spilled over, it must
be removed from the rinse aid
container.
If the rinse aid refill indicator bothers
you, e.g. if you use a combined
dishwasher detergent with a rinse aid
component, you can switch off the
rinse system.
Rinse aid spilled over can cause
excessive foaming during the wash
cycle.
4.
Close the lid of the rinse aid
reservoir.
aThe lid audibly clicks into place.
Tip:The function of the rinse aid is
limited in combination detergents. You
usually get better results by using
rinse aid.
Set the rinse aid amount
If there are streaks or water spots on the
ven, do you adjust the
remedy on.
1.
Press.
crockery left behind
amount of shine spo
2.
Approx. 3 seconds on
to access the basic settings.
Busy-
1.
Press.
aThe display shows Hxx.
27
