Engineer Programming Via the Keypad
67
Siemens Building Technologies
Fire Safety & Security Products
09.2008
10.6.4 Monitor
The Monitor feature presents an overview of all Keypads and Expanders
connected to the system.
To obtain an overview of the Expanders/Keypads*
connected to the system:
1.
Scroll to the EXPANDER programming option.
2.
Press Select.
3.
Scroll to desired Monitor programming option.
4.
Press SELECT.
Î
A list of detected Expanders displays.
5.
Scroll through the list and press SELECT on
preferred Expander.
The following parameters and details, if
applicable, are displayed:
Status:
online or offline
Serial Number:
used to track and identify
Firmware Version
Power parameters:
real-time voltage and
current readings
Battery voltage:
battery voltage level (SPC
PSU Expanders only)
Input state:
state of each zone input
associated with an Expander as follows: C:
Closed, O: Open, D; Disconnected, S: Short
(Expanders with inputs only)
6.
Press BACK to exit the menu.
*Monitor Keypads using the same menus and
following the Keypad menu instead of Expander.
10.6.5 Edit
To edit Expanders/Keypads*:
1.
Scroll to the EXPANDERS> EDIT programming option.
2.
Press SELECT.
3.
Scroll to the device to be edited and press
SELECT. The following parameters and
details, if applicable, are displayed for editing:
Names
Keypad Backlight:
normal, always, off
Buzzer Output:
active, silent
Keypad LED:
on, off
Areas:
(Areas must be enabled in
programming: FULL ENGINEER>
VARIABLES)
...EXPANDER...
BACK
SELECT
...MONITOR...
BACK
SELECT
EXPANDER 1
BACK
SELECT
STATUS:ONLINE
BACK
S/N 804
BACK
VER 1.1
16.MAR06
BACK
POWER
BACK
SELECT
BATTERY
BACK
SELECT
INPUT STATE
BACK
SELECT
...EXPANDERS...
BACK
SELECT
...EDIT...
BACK
SELECT
...EXPANDER 1...
BACK
SELECT
NAMES
BACK
SELECT
