Siemens SN53HS60AE, Инструкция по эксплуатации

Страница: 28 / 64

NLRinse System
The stated consumption values are
laboratory measured values which
are determined according to the
currently valid standard and on the
basis of the Eco 50° program and the
factory-set water hardness value of 13
- 16 °dH.
max
G
G
lance flushing system lance flushing system
G
s
lance flushing system
You can use dishes and glasses with
3.
If rinse aid has spilled over, it must
be removed from the rinse aid
container.
wash off without a hitch using the
rinse system and rinse aid.
Rinse aid spilled over can cause
excessive foaming during the wash
cycle.
rinse aid
For optimal drying results it is best
to use the rinse aid.
Only use rinse aid for household
dishwashers.
4.
Close the lid of the rinse aid
reservoir.
aThe lid audibly clicks into place.
Set the rinse aid amount
Filling rinse aid
If the rinse aid refill indicator lights up,
add rinse aid. Only use rinse aid for
household dishwashers.
If streaks or water spots remain on the
dishes, adjust the amount of rinse aid.
1.
Press.
1.
Press and lift the tab on the lid of
the rinse aid reservoir .
2.
Approx. 3 seconds on
to access the basic settings.
Busy-
aThe display shows Hxx. aThe
display shows
reflected
2
to give.
3.
Just as often on
until the display shows the factory
set value r05.
to press
4.
Just as often on press until
the desired amount of rinse aid
has been set.
1
– A low setting adds less rinse aid
during the wash cycle, reducing
the streaks on the dishes.
2.
The rinse aid
barrier max refill
share to the mar-
n.
28