Siemens SN43HW33VS, Руководство пользователя

Страница: 52 / 60

en
Troubleshooting
52
Fault Cause troubleshooting
Appliance does not start. Mains cable is not inserted.
1.
Check whether the socket works.
2.
Check whether the mains cable is
properly inserted in the socket and
on the rear of the appliance.
Appliance door is not closed
properly.
▶
Close the appliance door.
Programme starts automat-
ically. You did not wait until pro-
gramme ended.
▶
→ "Terminate programme",
Page 33
Appliance stops during the
programme or cuts out. Appliance door is not closed
properly.
▶
Close the appliance door.
Power and/or water supply
has been interrupted.
1.
Check the power supply.
2.
Check the water supply.
Top basket is pressing
against inner door and pre-
venting appliance door from
being closed securely.
▶
Check whether the rear panel of the
appliance is being pressed in by a
socket or hose holder that has not
been removed.
▶
Arrange the tableware so that no
parts project beyond the basket
and prevent the appliance door
from closing properly.
Mechanical damage
Fault Cause troubleshooting
Appliance door cannot be
closed. Door lock has been activ-
ated.
▶
Close the appliance door with
greater force.
Door cannot be closed due
to installation method.
▶
Check whether the appliance has
been installed properly.
When closed, the appliance door,
its decor or attached parts should
not knock against adjacent cabin-
ets or the worktop.
Lid on the detergent dis-
penser cannot be closed. Detergent dispenser or lid
are blocked by sticky deter-
gent residue.
▶
Remove detergent residue.