Siemens sitrans tr300, Руководство пользователя

Страница: 44 / 96

SITRANS TR200/TR300
Operating Instructions, 06/2010, A5E01071992-03
43
Functions
9
9.1 General information
You can operate the SITRANS TR300 using either the SIMATIC PDM parameterization
software or the HART communicator. You can operate the SITRANS TR200 using the
SIPROM T parameterization software.
The following functions are available to you when operating the SITRANS TR300/TR200:
● Identification
– Information on operational safety: Day, description, message, assembly number
● Device data; this information is read-only
– Manufacturer and product name
– Order number, device serial number
– Revision numbers for the firmware and hardware revision
● Information about the measuring procedure
– Sensor class and sensor type, e.g. Pt100 resistance thermometer or thermocouple
type B
– Sensor factor
– Sensor characteristic curve, e.g. linear temperature
– Measuring range and measuring unit
● Information on measurement interface
– Type of interface: standard, differential or mean value circuit
– Type of connection/sensor connection: two-wire, three-wire or four-wire connection
with resistance-type transmitters
– Resistors for line compensation
– Offset to the measuring signal
– Additional information for the cold junction in thermocouples: internal, external or fixed
– Enable/disable the broken wire or short circuit test
● Information about the output signal
– Filter time constant for noise suppression attenuation
– Output limit values: alarm and saturation limits
● Certificates and approvals
– The following information is read-only: Information whether the transmitter may be
operated in intrinsically safe mode or not. This function can only be performed using
the SIMATIC PDM parameterization software or with the HART communicator.