Siemens SITRANS FC330, Руководство по эксплуатации, Страница: 88 / 280

6.3.5 Wizards
The HMI wizard graphics show an overview of each HMI wizard and of the keys used to
navigate through the wizards. In the upper left corner of each view the wizard name (for
example "Process values") and the step name (for example "Unit") of the wizard is shown. In
the upper right corner the view number (for example 5 of 18 in the Process values wizard) is
shown.
2
1
①
View number
②
Wizard name
The purpose of the HMI wizards is to guide you through a quick set-up of various parameters.
The following HMI wizards are available:
● Quick commissioning
● Zero point adjustment
● Process values
● Inputs and outputs
● Gas application
● Pulsating flow
● Dosing application
Use the and keys to highlight the desired HMI wizard and press right key to enter the
wizard. The first view shows a short description of which settings can be done.
Key operation
Basic navigation in the HMI wizards is shown in the graphics.
To change settings, use the and keys to highlight wanted setting, then press key to
select. Confirm selection by pressing key again.
When you reach the end of the wizard, e.g. "Process values wizard is now finished", press
key to go back to wizard list.
6.3.5.1 Quick commissioning wizard (menu item 1.1)
The Quick commissioning wizard will guide you through configuration of parameters essential
for your application. You configure parameters essential for your application by selecting the
configuration path and subwizards appropriate for your application.
Commissioning
6.3 Local commissioning via HMI
SITRANS FC330
88
Operating Instructions, 01/2019, A5E44030648-AB