Siemens SITRANS F FUE380, Руководство по эксплуатации, Страница: 98 / 102

Parameter Factory settings Possible settings
Flow unit factor 3600 (for flow unit m
3
/h) Auto set from unit guide
Totalizer volume unit factor 1 Auto set from unit guide
Flow unit text m
3
/h Auto set from unit guide, but only m
3
/h
can be shown on display
Totalizer unit text m
3
Auto set from unit guide, but only m
3
can
be shown on display
Totalizer directions
Totalizer 1 direction
Forward Forward/Reverse/Forward net/Reverse
net
Totalizer 2 direction Reverse Forward/Reverse/Forward net/Reverse
net
Output A
Active
On On/off
Direction Factory pre-configured according order
code.
Preset: Forward
Forward/Reverse/Forward net/Reverse
net
Amount per pulse Factory pre-configured according order
code, i.e. 0.1 m
3
Unit: The same as Totalizer unit
Value freely selectable
Pulse width Factory pre-configured according order
code. Typically 5 ms
5, 10, 20, 50, 100, 200, 500 ms
Output B
Active
On On/Off
Function Alarm Pulse/Alarm/Call up
Direction No influence, while "Alarm" Forward/Reverse/Forward net/Reverse
net
Amount per pulse No influence, while "Alarm" Unit: The same as Totalizer unit
Value freely selectable
Pulse width No influence, while "Alarm" 5, 10, 20, 50, 100, 200, 500 ms
B.2 Factory settings for Modbus communication
Parameter Default setting
Slave device address 1
Data transmission rate 19 200 baud
Vertical parity position Even 1 stop
Response timeout 10000 ms
Response delay 5 ms
Interframe space 35 bits
The settings can be changed via SIMATIC PDM or via the Modbus.
Settings
B.2 Factory settings for Modbus communication
FUS380/FUE380
98
Operating Instructions, 09/2016, A5E00730100-AB