Result
You have replaced the 3RW5 communication module and can commission the 3RW5 soft starter
in the bus connection.
Set the communication parameters anew. If you backed up the communication parameters to
a micro SD card before replacement, you can transfer them from the micro SD card to the
replacement device. Please note that other parameters are also transferred in addition to the
communication parameters. For more information on the transferred parameters, refer to the
Equipment Manual of the 3RW5 soft starter.
9.3
Restoring factory settings
Effects of the factory setting
The following devices can be reset to the factory setting:
• 3RW5 soft starter
– The parameters of the 3RW5 soft starter are reset to the factory setting (depending on the
3RW5 soft starter).
– User accounts are deleted (depending on the 3RW5 soft starter).
– Parameters relevant to protection against explosion are deleted (depends on the
3RW5 soft starter).
• 3RW5 communication module
– The parameters of the 3RW5 communication module are reset.
• 3RW5 HMI High Feature
– The parameters of the 3RW5 HMI High Feature and the PIN for access protection are reset
to the factory setting.
• All devices
– The 3RW5 soft starter, the 3RW5 communication module, and the 3RW5 HMI High
Feature are reset to the factory settings, as described above.
Requirements
The master control lies with the source of the command to restore the factory setting.
Maintenance and service
9.3 Restoring factory settings
SIRIUS 3RW5 PROFINET communication modules
Equipment Manual, 05/2021, A5E35631297002A/RS-AD/004
143
