Siemens SIPROTEC4 6MD63, Руководство по протоколу

Страница: 44 / 66

Standard mapping 2-2
7SJ61...7SJ63, 7SJ65, 6MD63 PROFIBUS-DP – Bus mapping
C53000-L1840-B006-02
3-8
Offset Designation of the
SIPROTEC objects
Comments Internal
object no.
11/2 Rotor locked 1 = Rotor locked 6822
11/3 START-SUP pu 1 = Startup supervision Pickup 6823
3.2.1.14 Trip coil monitor
Offset Designation of the
SIPROTEC objects
Comments Internal
object no.
11/4 FAIL: Trip cir. 1 = 74TC Failure trip circuit 6865
3.2.1.15 Cold load pickup
Offset Designation of the
SIPROTEC objects
Comments Internal
object no.
11/5 CLP OFF 1 = Cold-load-pickup is switched OFF 1994
11/6 CLP BLOCKED 1 = Cold-load-pickup is BLOCKED 1995
11/7 CLP running 1 = Cold-load-pickup is RUNNING 1996
12/0 Dyn set. ACTIVE 1 = Dynamic settings are ACTIVE 1997
3.2.1.16 Measurement supervision
Offset Designation of the
SIPROTEC objects
Comments Internal
object no.
12/1 Fail I Superv. 1 = Failure: General current supervision 161
12/2 Failure <Sum>I 1 = Failure: Current summation 162
12/3 Fail Ph. Seq. 1 = Failure: Phase sequence 171
12/4 MeasSup OFF 1 = Measurement supervision is switched OFF 197
3.2.1.17 Set point alarms
Offset Designation of the
SIPROTEC objects
Comments Internal
object no.
12/5 SP. Op Hours> 1 = Set point operating hours 272
12/6 SP. IA dmd> 1 = Set point phase A dmd> 273
12/7 SP. IB dmd> 1 = Set point phase B dmd> 274
13/0 SP. IC dmd> 1 = Set point phase C dmd> 275
13/1 SP. I1 dmd> 1 = Set point positive sequence I1 dmd> 276
13/2 SP. |Pdmd|> 1 = Set point |Pdmd|> 277
13/3 SP. |Qdmd|> 1 = Set point |Qdmd|> 278
13/4 SP. |Sdmd|> 1 = Set point |Sdmd|> 279
13/5 SP. 37-1 alarm 1 = Set point 37-1 Undercurrent alarm 284
13/6 SP. PF(55)alarm 1 = Set point 55 Power factor alarm 285
13/7 <reserved> –