Siemens SINUMERIK 840 sl, Руководство пользователя

Страница: 17 / 68

Power supply connector for MCP 398C
Connection type Strain-relief clamp connection
Connection screw M2.5 screw with cross-slot
Operating tool Screwdriver blade 0.6x3.5, PH0, PZ0 (DIN
5264, ISO 8764/2-PH, ISO 8764/2-PZ)
Specified tightening torque Nm 0.4 ... 0.5
Conductor cross-section min./max.
Solid mm² 1.3 … 3.3
Finely stranded mm² 1.3 … 3.3
With ferrule with collar DIN46228/4 mm² 1.3 … 2.5
With ferrule DIN46228/1 mm² 1.3 … 3.3
AWG cables, solid or stranded AWG 12 … 16
2.3.2 Description
Switch S1
MCP set up as PN
Table 2-3 General switch S1 setting
1-8 9 10 Meaning
See Table "Settings of switch S1" on on PN
off off IE (default)
The two switches S1-9 and S1-10 must be set to "on" for the PN functionality.
The switches S1-1 to S1-8 define the default device name.
Up to 128 default device names are possible. If these default device names are used, there is
no need for initialization of the MCP.
Note
Reconfiguration of preset device names not possible
You cannot reconfigure preset device names, for example, with STEP 7 "Device initialization".
Note
SINUMERIK control must support the PN functionality of the MCP
When you connect the MCP to a SINUMERIK control as a PROFINET component, make sure
that this functionality is supported by the relevant control.
DCP mode:
No default device name is available in this mode. You must set the device name by means of
Description
2.3 Interfaces
Machine control panel: MCP 398C
Manual, 07/2018, A5E43199783B AB
17