Siemens SINUMERIK 828D Turning, Руководство по эксплуатации функций

Страница: 1582 / 1799

W1: Tool offset
18.12 Working with tool environments
Basic Functions
1582
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
Any rotations and component exchanges initiated by the adapter transformation, toolholder with orientation
capability and kinematic transformation, are part of the tool environment. They are thus always performed, even
if the corresponding length component is not supposed to be included. If this is undesirable, tool environments
must be defined, in which the corresponding transformations are not active. In many cases (i.e. any time a
transformation or toolholder with orientation capability is not used on a machine), the data sets stored for the tool
environments automatically fulfill these conditions, with the result that the user does not need to make special
provision.
MD20360 $MC_TOOL_PARAMETER_DEF_MASK
The two least significant bits of this machine data specify how the wear (bit 0) and tool length (bit 1) are to be
evaluated if a diameter axis is used for turning and grinding tools.
If the bits are set, the associated entry is weighted with the factor 0.5. This weighting is reflected in the tool length
returned by
GETTCOR
.
Example:
MD20360 $MC_TOOL_PARAMETER_DEF_MASK = 3 (definition of tool parameters).
MD20100 $MC_DIAMETER_AX_DEF="X" (Geometry axis with face axis funtion)
X is diameter axis (standard turning machine configuration):
_T
INT
Internal T number of tool
If this parameter is not specified, or if its value is 0, the tool stored in _STAT is used.
If the value of this parameter is -1, the T number of the active tool is used. It is also
possible to specify the number of the active tool explicitly.
Note
If _STAT is not specified, the current status is used as the tool environment. Since _T = 0
refers to the T number saved in the tool environment, the active tool is used in that
environment, i.e. parameters _T = 0 and _T = -1 have the same meaning in this special case.
_D
INT
Cutting edge of the tool. If this parameter is not specified, or if its value is 0, the D
number used is based on the source of the T number. If the T number from the tool
environment is used, the D number of the tool environment is also read, otherwise the D
number of the currently active tool is read.
_DL
INT
Number of the local compensation. If this parameter is not specified, the DL number
used is based on the source of the T number. If the T number from the tool environment
is used, the D number of the tool environment is also read, otherwise the D number of
the currently active tool is read.
N30 $TC_DP1[1.1] = 500
N40 $TC_DP2[1.1] = 2
N50 $TC_DP3[1.1] = 3.0 ; Geometry L1
N60 $TC_DP4[1,1]= 4.0