Siemens SINAMICS V20 Series, Руководство по эксплуатации

Страница: 33 / 274

Commissioning
5.1 The built-in Basic Operator Panel (BOP)
SINAMICS V20 Inverter
Operating Instructions, 07/2012, A5E03728167
33
Normal editing of parameters
NOTICE
Pressing or for longer than two seconds to quickly increase or decrease the
parameter numbers or indexes is only possible in the parameter menu.
This editing method is best suited when small changes are required to parameter numbers,
indexes, or values.
●
To increase or decrease the parameter number, index, or value, press or for less
than two seconds.
● To quickly increase or decrease the parameter number, index, or value, press or
for longer than two seconds.
● To confirm the setting, press
OK OK
.
● To cancel the setting, press
M M
.
Digit-by-digit editing
NOTICE
Digit-by-digit editing of parameter numbers or indexes is only possible in the parameter
menu.
Digit-by-digit editing can be performed on parameter numbers, parameter indexes, or
parameter values. This editing method is best suited when large changes are required to
parameter numbers, indexes, or values. For information about the inverter menu structure,
refer to Section "Inverter menu structure (Page 31)".
●
In any edit or scroll mode, digit-by-digit editing is entered by a long press (> 2 s) on
OK OK
.
● The digit-by-digit editing always starts with the rightmost digit.
● Each digit is selected in turn by pressing
OK OK
.
● Pressing
M M
once moves the cursor to the rightmost digit of the current item.
● Pressing
M M
twice in succession exits the digit-by-digit mode without changing the item
being edited.
● Pressing
OK OK
on a digit when there are no further digits to the left saves the value.
● If more digits are required to the left, then these must be added by scrolling the existing
leftmost digit above 9 to add more digits to the left.
● Pressing or for longer than two seconds enters fast digit scrolling.