Siemens SINAMICS V20 Inverter, Руководство по эксплуатации, Страница: 57 / 426

Commissioning via the built-in BOP
5.1 The built-in Basic Operator Panel (BOP)
SINAMICS V20 Converter
Operating Instructions, 10/2019, A5E34559884-012
55
•
When navigating through a menu, it moves the selection up through the screens available.
•
When editing a parameter value, it increases the displayed value.
•
When the converter is in RUN mode, it increases the speed.
•
Long press (> 2 s) of the key quickly scrolls up through parameter numbers, indices, or values.
• When navigating through a menu, it moves the selection down through the screens available.
•
When editing a parameter value, it decreases the displayed value.
• When the converter is in RUN mode, it decreases the speed.
•
Long press (> 2 s) of the key quickly scrolls down through parameter numbers, indices, or values.
+
Reverses the direction of rotation of the motor. Pressing the two keys once activates reverse motor rota-
tion. Pressing the two keys once again deactivates reverse rotation of the motor. The reserve icon ( )
on the display indicates that the output speed is opposite to the setpoint.
Note
Unless otherwise specified, operations of the above keys always indicate short press (< 2 s).
Converter status icons
Converter has at least one pending fault.
Converter has at least one pending alarm.
: Converter is running (motor speed may be 0 rpm).
(flashing): Converter may be energized unexpectedly (for example, in frost protection mode).
Motor rotates in the reversed direction.
: Converter is in HAND mode.
(flashing): Converter is in JOG mode.
5.1.2 Converter menu structure
Menu Description
50/60 Hz selection menu This menu is visible only on first power-up or after a factory reset.
Main menu
Display menu (default display) Basic monitoring view of key parameters such as frequency, voltage,
current, DC-link voltage, and so on.
Setup menu Access to parameters for quick commissioning of the converter.
Parameter menu Access to all available converter parameters.