Siemens SINAMICS G150, Руководство по эксплуатации

Страница: 114 / 240

Operation 11/03
SINAMICS G150
6-32
Operating Manual
6.4.2 Control via PROFIBUS
6.4.2.1 General
"DP1 (PROFIBUS)" Diagnostics LED
The PROFIBUS diagnostics LED is located on the front of the control unit (see
Section 6.4) Its statuses are described in the following table.
Table 6-5 Description of the LEDs
Color State Description
------ Off No voltage applied to control unit
Green Continuously lit PROFIBUS is ready for communication and cyclic communication is
taking place
Green Flashing 0.5 Hz PROFIBUS is ready for communication and cyclic communication is
not taking place
Red Continuously lit At least one PROFIBUS fault is present. PROFIBUS is not ready for
operation (e.g. after power-on)
6.4.2.2 Setting the PROFIBUS Address
Two methods are available for setting the PROFIBUS address:
•
The address switches (DIP switches) on the front of the control unit behind the
cover plate (see Section 6.4.1).
If you use the address switch, parameter p0918 is read only and displays the
address that is set.
If the switch is reset, the new setting does not become effective until the control
unit is reset.
•
Entering parameter p0918 on the operator panel.
You can
only do this if the address has been set to 0 or 127 using the address
switch, that is, all switches from S1 to S7 are set to ON or OFF.
In this case, changes become effective immediately.
Table 6-6 PROFIBUS address switches
Switch Significance Technical data
S1 2
0
= 1
S2 2
1
= 2
S3 2
2
= 4
S4 2
3
= 8
S5 2
4
= 16
S6 2
5
= 32
S7 2
6
= 64
Significance
ON
OFF
2 0
1
S1
Example
1
ON
OFF
2 1
2
2 2
4
2 3
8
2 4
16
2 5
32
2 6
64
S7
...
+ 4 + 32 = 37