Siemens SINAMICS G120XA, Руководство по эксплуатации

Страница: 688 / 918

43: ft wg
44: m wg
45: % r.h.
46: g/kg
47: ppm
48: kg/cm²
Dependency: Only units of parameters with unit group 9_2 can be changed over using this parameter.
See also: p11027
p11027 Free tec_ctrl 0 unit reference quantity / Ftec0 unit ref
Access level: 1 Calculated: - Data type: FloatingPoint32
Can be changed: T Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: -
Min:
0.01 Max:
340.28235E36 Factory setting:
1.00
Description: Sets the reference quantity for the unit of the parameters of the free technology controller 0.
When changing over using changeover parameter p11026 to absolute units, all of the parameters involved refer to the
reference quantity.
Dependency: See also: p11026
p11028 Free tec_ctrl 0 sampling time / Ftec0 t_samp
Access level: 3 Calculated: - Data type: Integer16
Can be changed: T Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: 7030
Min:
0 Max:
4 Factory setting:
2
Description: Sets the sampling time for the free technology controller 0.
Value: 0: Reserved
1: 128 ms
2: 256 ms
3: 512 ms
4: 1024 ms
r11049.0...11 CO/BO: Free tec_ctrl 0 status word / Ftec0 stat_word
Access level: 3 Calculated: - Data type: Unsigned32
Can be changed: - Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: 7030
Min:
- Max:
- Factory setting:
-
Description: Displays the status word of the free technology controller 0.
Bit field: Bit Signal name 1 signal 0 signal FP
00 Deactivated Yes No -
01 Limited Yes No -
08 Actual value at the minimum Yes No -
09 Actual value at the maximum Yes No -
10 Output at the minimum Yes No -
11 Output at the maximum Yes No -
Parameters
7.3 Parameters
SINAMICS G120XA converter
686
Operating Instructions, 03/2019, FW V1.0, A5E44751205B AB