Siemens SINAMICS G110M, Руководство по эксплуатации, Страница: 407 / 428

A.1.6 Firmware version 4.7
Table A-6 New functions and function changes in Firmware 4.7
Function SINAMICS
G120 G120D
*
0
*
&
&
8
3
&
8
%
&
8
(
&
8
6
&
8
'
&
8
'
1 Supporting the identification & maintenance datasets (I&M1 … 4) ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓
2 Fall in pulse rate with increased drive power required by the motor
• The converter temporarily lowers the pulse frequency if required when the
motor is started up, and simultaneously increases the current limit.
✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓
3 S7 communication
• Direct data exchange between the converter and human-machine interface
(HMI).
• Increase in communication performance with the engineering tools and sup‐
port of the S7 routing
✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓
4 The basic functions of Safety Integrated are unrestrictedly available in all control
types with 1FK7 encoderless permanent-field synchronous motors - - - - - - ✓ -
5 Encoderless 1FK7 synchronous motors are supported
• Direct motor selection based on the article number with associated code
number
• It is not necessary to input individual motor data
- - - - - - ✓ -
6 Pulse input as source of setpoint value
• The converter calculates its speed setpoint from a sequence of pulses at the
digital input.
- - - - - ✓ - -
7 Dynamic IP address assignment (DHCP) and temporary device names for PROFI‐
NET ✓ ✓ ✓ - ✓ ✓ ✓ ✓
8 PROFIenergy Slave profile 2 and 3 ✓ ✓ ✓ - ✓ ✓ ✓ ✓
9 Uniform behavior for component replacement
• After a component is replaced, a converter with activated Safety Integrated
will report what type of component has been replaced using a unique code.
✓ ✓ - - ✓ ✓ ✓ ✓
10 Improved direct-component control in PM230
• Optimized efficiency for pump and fan applications - - ✓ - - - - -
11 Rounding down of BACnet and macros - - ✓ - - - - -
Appendix
A.1 New and extended functions
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL
405