Siemens SINAMICS G110M, Руководство по эксплуатации, Страница: 108 / 428

5.4 Quick commissioning
5.4.1 Motor data using p300 and p301
Preassigned motor data using p0300 and p0301
The SINAMICS G110M software has been configured to utilize the input of the motor data using
a motor code. There are two parameters associated with this function, they are p0300 (motor
type) and p0301 (motor code).
When the SINAMICS G110M is ordered and delivered as a complete system, the motor data is
already correctly configured and does not require any adjustment.
When the SINAMICS G110M is ordered and delivered as separate items, the user must install the
system and enter the relevant motor data during basic commissioning.
When commissioning of the motor is required, there are two options available to the user:
Commissioning using motor codes
When commissioning using the motor codes, for example, in STARTER utilizing the "Expert List",
the follow steps should be performed:
1. Set p0010 = 1.
2. Set p0300 to 100 (1LE1 standard induction motor) or 177 (1LA7 standard induction motor).
3. Enter the relevant motor code into p0301 as shown in the following table:
Motor type Power rating (kW) Motor code for p0301
1LA7 0.37 17726
1LE1 0.75 12017
1LE1 1.10 12018
1LE1 1.50 12019
1LE1 2.20 12020
1LE1 3.00 12021
1LE1 4.00 12023
When the relevant motor code is entered, the motor data automatically assigned for the selected
motor. The user can then complete the commissioning process without the need to perform a
motor ID.
Commissioning without using motor codes
When commissioning the system without using motor codes, the following steps must be
performed, otherwise the motor will not be commissioned correctly.
1. Set p0010 = 1 (Enter the quick commissioning mode).
2. Set p0300 = 1 (Induction motor [rotating]).
Commissioning
5.4 Quick commissioning
Distributed converter for SIMOGEAR geared motors
106
Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL