Siemens SIMOTICS XP 1MB155, Руководство по эксплуатации, Страница: 21 / 152

1MB155 / 1MB555
Operating Instructions, 03/2018, A5E41926185A
19
Description
3
3.1 Area of application
The three-phase machines of this series are used as industrial drives. They are designed for
a wide range of drive applications both for line operation as well as in conjunction with
frequency converters.
They are characterized by their high power density, extreme robustness, long service life
and outstanding reliability.
Intended use of the machines
These machines are intended for industrial installations. They comply with the harmonized
standards of the series EN / IEC 60034 (VDE 0530). It is prohibited to use these motors in
hazardous zones if the marking on the rating plate does not explicitly permit line or converter
operation. If other/more wide-ranging demands (e.g. protection so that they cannot be
touched by children) are made in special cases – i.e. use in non-industrial installations –
these conditions must be ensured by the customer.
Note
Machine directive
Low-voltage motors are components designed for installation in machines in accordance
with the current Machinery Directive. Commissioning is prohibited until it has been absolutely
identified that the end product is in conformance with this Directive. Please observe the
EN / IEC 60204-1 standard.
Use of machines without CE marking
Machines without CE marking are intended for operation outside the European Economic
Area (EEA). Do not use any machines without a CE marking in the EEA!
Use in hazardous areas
Explosion-proof electrical machines correspond to standards of the IEC/EN 60034 and
IEC/EN 60079 series. Only operate the machine in hazardous areas, strictly complying with
the specifications of the responsible supervisory authority. The relevant supervisory authority
is responsible for determining the hazard level of each area and classifying the zones. The
type of protection as well as special regulations are stamped on the rating plate or in the test
certificate. If the certificate number is supplemented by an X, to safely operate the machine
observe the special notes in the operating instructions or if available in the EC or EU type-
examination certificate or in the IECEx Certificate of Conformity. Operation with a converter
must be certified. It is essential that you observe the separate manufacturer's information
and instructions.