Siemens Simotics M-1FE1 Series, Руководство по установке оборудования

Страница: 79 / 150

Mechanical mounting
5.4 Mounting the stator with the spindle housing
1FE1 synchronous built-in motors
Hardware Installation Manual, 12/2016, 610.43000.40b
79
Example B: Vertical mounting of the spindle housing over the stator
Use this joining procedure when the connection cables exit from the smaller cooling jacket
diameter.
Procedure
1 Stator with cooling jacket 5 Cable entry
2 O-ring seals (four) 6 Connecting cables
3 Axial stop 7 Internal tensioning spindle
4 Spindle housing 8 Lifting lug / eyebolts
Figure 5-12 Vertical mounting of the spindle housing over the stator, steps 2, 3 and 5
1. Check that the four O-ring seals are fitted correctly.
2. Position the stator on the axial stop.
3. Remove the internal tensioning spindle from the stator.
4. Position the spindle housing so that you can route the electrical cables through the cable
gland of the spindle housing or the bearing shield later.
5. Place the spindle housing over stator from above.
Note
•
If necessary, push the the spindle housing by hand to the final position.
•
When joining, ensure that the O-ring seals remain in the stator slots.