Siemens Simotics HV C 1NA14544WA600AG0-Z, Инструкция по эксплуатации и монтажу

Страница: 53 / 112

6.2.4 Terminal box
The type designation of the terminal box for connecting the power cables can be found in the
technical data. An illustration can be found in Chapter "Spare parts" (Page 91).
The maximum conductor cross-section that can be connected and the permissible cable
external diameter are listed in the "Technical data and drawings" section. The connecting
cables can be sealed and secured at every entry point into the terminal box, using the sealing
insert supplied.
See also
Technical data and drawings (Page 101)
Rotating the terminal box
Depending on the particular version, the terminal box can be rotated. It can then be rotated
through increments of 90° corresponding to the connection direction.
If necessary, contact your Service Center (Page 99).
6.2.5 Connecting the grounding conductor
The grounding conductor cross-section of the machine must be in full conformance with the
installation specifications and to IEC 60034-1.
External conductor cross-section S
mm²
Grounding conductor cross-section
mm²
4 4
6 6
10 10
16 16
25 25
35 25
50 25
70 35
95 50
120 70
150 70
185 95
240 120
300 150
400 185
There is a hexagon bolt with a flat washer and a spring washer on the stator frame at the
designated connecting point for the grounding conductor.
Electrical connection
6.2 Preparation
SIMOTICS HV C 1NA14544WA600AG0-Z
Operating Instructions 06/2018
53