Siemens SIMATIC, Руководство по эксплуатации

Страница: 29 / 182

Wiring
4.3 Inserting and removing fail-safe connection modules and electronic modules
ET 200pro Distributed I/O System - Fail-Safe Modules
Operating Instructions, 05/2007, A5E00394073-02
29
Terminal Assignment of Connection Modules
The terminal assignment of the connection modules depends on which electronic module is
inserted.
See also
Block Diagram of 8/16 F-DI DC24V PROFIsafe Electronic Module (Page 58)
Wiring of Inputs of 8/16 F-DI DC24V PROFIsafe Electronic Module (Page 63)
Use Case 1: Safety Mode SIL2/Category 3 (Page 65)
Use Case 2: Safety Mode SIL3/Category 3 (Page 67)
Use Case 3: Safety Mode SIL3/Category 4 (Page 77)
Wiring the 4/8 F-DI/4 F-DO DC24V/2A PROFIsafe Electronic Module's Inputs (Page 96)
Wiring of Outputs of the 4/8 F-DI/4 F-DO DC24V/2A PROFIsafe Electronic Module (Page 97)
Block Diagram of the F-Switch PROFIsafe Electronic Module (Page 109)
Wiring of Inputs of the F-Switch PROFIsafe Electronic Module (Page 114)
Use Case 1: Safety Mode of F-Switch PROFIsafe (Page 116)
Use Case 2: Safety Mode SIL3/Category 3 (Page 116)
Use Case 3: Safety Mode SIL3/Category 4 (Page 125)
4.3 Inserting and removing fail-safe connection modules and electronic
modules
Inserting and Removing Modules
Fail-safe modules in ET 200pro are inserted and removed in the same way as all standard
modules in an ET 200pro.
Inserting and Removing Modules During Operation
F-modules can be removed and inserted during operation in exactly the same way as
standard modules in ET 200pro.
Follow the instructions in the
"Maintenance and Service" chapter in the ET 200pro
Distributed I/O Device manual.