Siemens SIMATIC RF300, Системное руководство

Страница: 53 / 474

made. Note that the values "02", "03" and "04" bring about a reduction of the power of
approximately 50%. Settings outside the range (02 ... 08) have the effect of setting the default
value (0.6 W). In this case, there is no error message for reasons of compatibility.
4.2.2 Field data of ISO transponders (MDS D)
The limit distances (S
g
) and operating distances (S
a
) along with the length of the transmission
window for each reader-transponder combination are listed in the tables below.
Observe the following information for field data of ISO transponders:
• A maximum median deviation of ±2 mm is permitted in static mode (without affecting the
field data).
• In dynamic mode, make sure that rectangular transponders cross the antenna field in the
longitudinal direction.
Table 4-10 Field data RF310R reader
Length of the transmission
window (L)
Operating distance (S
a
) Limit distance (S
g
)
MDS D100 40 2...93 105
MDS D124 30 2...64 72
MDS D126 90 2...65 73
MDS D139 105 5...96 109
MDS D160 30 2...39 44
MDS D165 130 2...90 102
MDS D200 120 2...80 90
MDS D261 80 2...74 83
MDS D324 30 2...47 63
MDS D339 85 5...74 84
MDS D400 90 2...90 105
MDS D423 55 2...35 40
MDS D424 35 1...68 75
MDS D425 30 1...22 25
MDS D426 90 5...75 90
MDS D428 30 1...40 45
MDS D460 30 1...32 38
MDS D524 35 1...70 78
MDS D525 30 1...22 25
MDS D526 90 5...80 90
MDS D528 30 1...43 48
MDS D560 30 1...32 38
All values are in mm
Planning the RF300 system
4.2 Field data for transponders, readers and antennas
SIMATIC RF300
System Manual, 02/2021, C79000-G8976-C345-09
53