Siemens SIMATIC PC 847B, Руководство по эксплуатации

Страница: 107 / 232

Interrupt, error and system messages
12.2 BIOS POST codes
SIMATIC Rack PC 847B
Operating Instructions, 06/2008, A5E02203168-01
107
12.2 BIOS POST codes
The section below lists the POST codes relevant to users in chronological order of
occurrence: Contact Customer Support for information on all other POST codes.
Display
(hex)
Meaning Description To correct or avoid errors
16H TP_CHECKSUM BIOS checksum test Service event
28H TP_SIZE_RAM Determine DRAM size Replace the memory modules
2AH TP_ZERO_BASE Set base RAM 64KB to 0 Replace the memory modules
2CH TP_ADDR_TEST Check address busses Replace the memory modules
2EH TP_BASERAML BaseRam Low Replace the memory modules
30H TP_BASERAMH BaseRam High Replace the memory modules
38H TP_SYS_SHADOW BIOS is copied to DRAM Replace the memory modules
3AH TP_CACHE_AUTO Determine processor cache Replace the processor
22H TP_8742-TEST Test the keyboard
controller
Check whether the keyboard is
connected or defective
3CH TP_ADV_CS_CONFIG Configure the advanced
chipset
Run a test by disabling the
hardware components in Setup
49H TP_PCI_INIT Initialize the PCI interface Run a test by disabling the
hardware components in Setup, or
by removing the expansion
modules installed on the bus
module
55H TP_USB_INIT Activation of the USB
hardware
Removal of USB devices
4AH TP_VIDEO Initialize the video interface
5CH TP_MEMORY_TEST System memory test Replace the memory modules
60H TP_EXT_MEMORY System memory test Replace the memory modules
62H TP_EXT_ADDR Address bus test Replace the memory modules
90H TP_FDISK Initialization and test of the
hard disk hardware
Disconnect the HDD, replace it if
necessary
95H TP_CD Initialization and test of the
CD hardware
Disconnect the CD-ROM drive,
replace it if necessary
98H TP_ROM_SCAN Search for BIOS
expansions
Run a test by disabling the
hardware components in Setup, or
by removing the expansion
modules installed on the bus
module
BCH TP_PARITY Test of memory modules Replace the memory modules
00H BIOS POST completed.
Loading operating system