Installing the Device
2.4.2 Mounting the Device to a Panel
3. Push the device against the bottom of the DIN rail, then let go of the sliding
release to latch the device.
Removing the Device
To remove the device from a DIN rail, do the following:
1. Insert a flathead screwdriver into the slot of the sliding release and move it
down.
1
2
1
1
2
3
1
DIN Rail
2
DIN Rail Adapter
Figure 2.2
Removing the Device from a DIN Rail
2. Swing the bottom of the device away from the DIN rail.
3. Lift the device off the DIN rail.
2.4.2
Mounting the Device to a Panel
For panel installations, the RUGGEDCOM RS900W can be equipped with panel
adapters pre-installed on the top and bottom of the chassis. The adapters allow the
device to be attached to a panel using screws.
To mount the device to a panel, do the following:
1. Prepare mounting holes in the panel where the device is to be installed.
RUGGEDCOM RS900W
Installation Manual, 04/2021, C79000-G8976-1028-13
11
