Siemens SIMATIC NET SCALANCE WxM763, Руководство по эксплуатации

Страница: 56 / 80

Connection
6.3 Ethernet
SCALANCE WxM763
56
Operating Instructions, 03/2022, C79000-G8976-C653-01
Use copper cables with the following properties to wire the power connector:
•
Two-wire cable with 0.5 to 1.5 mm 2 Cross-section per wire
• Permitted tensile load at least 10 N. - UL
• List of cables according to the national installation regulations. In areas where NEC or
CEC applies: Type PTLC or ITC
You can find additional information in the section "Terminals (Page 22)".
The "L1" and "L2" LEDs indicate the current range of the power supply, see the section
"LEDs (Page 29)".
6.3 Ethernet
The device has four Ethernet interfaces located on the front of the device. Connection to
Industrial Ethernet uses RJ45 connection technology with MDI-X assignment.
Position
The figure shows the position of the connectors to Industrial Ethernet with 10/100/1000
Mbps.