Siemens SIMATIC Mobile Client900WXN, Руководство по эксплуатации

Страница: 81 / 94

Technical specifications
7.4 Specifications
Mobile Client900WXN
Operating Instructions, 04/2015, A5E35883103-AB
81
7.4.4 Ambient conditions for transport and storage
Mechanical and climatic transport and storage conditions
The transportation and storage conditions of this HMI device exceed requirements in
accordance with IEC 61131-2. The following specifications apply to the transportation and
storage of an HMI device in its original packaging.
The climatic conditions comply with the following standards:
● IEC 60721-3-3, Class 3K7 for storage
● IEC 60721-3-2, Class 2K4 for transport
The mechanical conditions are compliant with IEC 60721-3-2, Class 2M2.
The following table shows the transport and storage conditions for the Mobile Client.
Type of condition Permissible range
Free fall ≤ 1 m
Temperature –25 to +70 °C
Atmospheric pressure 1080 to 660 hPa,
corresponds to an elevation of -1000 to 3500 m
Relative humidity 5 to 95%, without condensation
Sinusoidal vibration in accordance with
IEC 60068-2-6
5 to 8.4 Hz: 3.5 mm
8.4 to 150 Hz: 9.8 m/s
2
Shock in accordance with IEC 60068-2-27 25 g, 6 ms, 1000 shocks per axis
Note
In the following cases, ensure that no humidity can settle on or in the HMI device:
•
Transportation of the HMI device in low temperatures
•
Under extreme temperature variations
The HMI device must have acquired room temperature before it is put into operation. Do not
expose the HMI device to direct radiation from a heater in order to warm it up. If dewing has
developed, wait approximately 4 hours until the HMI device has dried completely before
switching it on.
The following points must be adhered to in order to ensure a fault-free and safe operation of
the HMI device:
● Proper transportation and storage
● Proper installation and mounting
● Careful operation and maintenance
The warranty for the HMI device will be deemed void if these stipulations are not heeded.