Siemens SIMATIC IPC677E, Руководство по эксплуатации

Страница: 76 / 158

Expanding the device and assigning device parameters
6.3 Memory modules
SIMATIC IPC677E
76
Operating Instructions, 04/2019, A5E45117996-AA
6.3 Memory modules
6.3.1 Usable memory modules
Combination options for memory modules
You can equip each device with 1, 2 or 4 memory modules of the same capacity.
Combinations of three memory modules or the mixing of memory capacities is not permitted.
This allows you to expand IPC memory capacity to up to 64 GB, of which you can use
approx. 3.2 GB for operating systems and applications with 32-bit operating systems.
Depending on the number of memory modules used, these are inserted in defined slots on
the motherboard.
The slots are labeled on the motherboard.
Combination option Channel A Channel B (external) Maximum expansion
Slot X19
DIMM1-1
Slot X190
DIMM1-2
Slot X20
DIMM2-1
Slot X200
DIMM2-2
Combination 1 - - 4 GB / 8 GB /
16 GB
- 16 GB
Combination 2 4 GB / 8 GB /
16 GB
- 4 GB / 8 GB /
16 GB
- 32 GB
Combination 3 Combinations of three memory modules are not permitted
Combination 4 4 GB / 8 GB /
16 GB
4 GB / 8 GB /
16 GB
4 GB / 8 GB /
16 GB
4 GB / 8 GB /
16 GB
64 GB
Usable memory modules
● DIMM DDR4 memory modules
● Memory transaction rate 2666 MT/sec "unbuffered"
● "without ECC"
Conditions of use of memory modules
● Memory is operated in dual-channel mode if two modules are installed.
● Only modules of the same module organization 2Rx8 or 1Rx8 may be used per channel.
● If expansion cards with their own memory, such as graphics cards, with 256 MB or more
are used, the memory that can be used for the operating system or applications may be
less than 64 GB.
● In case of operating errors, it may be sufficient to remove one or two memory modules or
to use a memory module with lower capacity so that the physical memory expansion on
the motherboard and the reserved memory of the expansion card do not overlap.
See also
Opening the Device (Page 71)