Siemens Simatic IPC647C, Руководство по эксплуатации

Страница: 208 / 246

Detailed descriptions
16.7 CP 1616 onboard communications processor
SIMATIC IPC647C
208
Operating Instructions, 12/2010, A5E02669337-02
Procedure
To check the network address, follow these steps:
66.
If the AMT server uses the same network address as the operating system of the AMT
PC (most common situation): You can obtain the address of the AMT server in the
command line in Windows using "ipconfig" and in UNIX using "ifconfig".
67. If the AMT server and operating system do not use the same network address, ask your
network administrator for the address you have been assigned.
16.6.6 Forcing user consent
Introduction
When establishing a connection to the AMT PC, the KVM viewer may prompt the user to
enter a six-figure code. This code is displayed on the screen of the AMT PC. The user of the
AMT PC must inform the user of the KVM viewer of this code.
Procedure
To set up this code query on the KVM viewer, follow these steps:
68.
Select "Intel(R) AMT Configuration > User Consent" in the MEBx.
69. Select the value "KVM" for "User Consent".
To allow a user with administrator privileges to avoid this code query, follow these steps:
70.
Select "Intel(R) AMT Configuration > User Consent" in the MEBx.
71. Enable "Opt-in configurable from remote IT".
16.7 CP 1616 onboard communications processor
16.7.1 Introduction
The CP 1616 onboard allows the connection of industrial PCs to Industrial Ethernet.
The basic characteristics of the PCS 1616 onboard are:
●
Optimized for PROFINET IO
● With Ethernet realtime ASIC ERTEC 400
● Three RJ45 sockets for connecting terminal devices or addition network components
● Integrated 3-port real-time switch
● Automatic hardware detection