Siemens SIMATIC IPC547J, Руководство по эксплуатации

Страница: 186 / 198

Technical support
B.2 Troubleshooting
186
Operating Instructions, 01/2021, A5E43920357-AA
B.2 Troubleshooting
B.2.1 Problems with device functions
Problem Cause Remedy
The device is not operational No power supply
• Check the power supply, the power cable and the
power plug.
• Check to see if the on-off switch is in the correct
position.
Device is being operated outside
the specified ambient conditions
• Check the ambient conditions.
• After transport in cold weather do not turn the
power on until after a waiting period of
approximately 12 hours.
The monitor remains dark The monitor is switched off Switch on the monitor.
The monitor is in "power save"
mode
Press any key on the keyboard.
The brightness button has been set
to dark
Increase brightness using the brightness button.
Detailed information can be found in the operating
manual for the monitor.
The power cord or the monitor
cable is not connected.
• Check if the power cord is properly connected to
the monitor and to the system unit or to the
grounded shockproof power outlet.
• Check to make sure the monitor cable is properly
connected to the system unit and the monitor.
Contact your technical support team if the screen still
remains dark after all these controls and measures.
The mouse pointer does not
appear on the screen
The mouse driver is not loaded Check whether the mouse driver is properly installed
and available when you start the user program.
Detailed information about the mouse driver is
available in the corresponding documentation.
Mouse not connected
• Check to make sure that the mouse cable is
properly connected to the system unit.
• If you use an adapter or extension cable for the
mouse cable make sure to check these
connections as well.
Contact your technical support team if the mouse
pointer still does not appear on the screen after
these controls and measures.
Time and/or date of the PC is
not correct
1. Open the firmware configuration menu. To do
this, press the <F2> key during the boot opera-
tion.
2. Set the date and the time in the "Main" tab.