Siemens SIMATIC IPC547C, Начало работы

Страница: 21 / 36

Connecting
5.2 Connecting the device to power
SIMATIC IPC547C
Getting Started, 06/2009, A5E02411398-01
21
Localized information
Outside of the USA and Canada, operation on a 230 V power supply:
This device is equipped with a safety-tested power cord which may only be connected to a
grounded shockproof power outlet. If you choose not to use this cable, you must use a
flexible cable of the following type: Min. 18 AWG conductor cross-section and 15-A / 250-V
shock-proof connector. The cable set must be compliant with safety regulations and
stipulated IDs of the country where the system is to be installed.
For the USA and Canada:
A CSA or UL-listed power cord must be used for the United States and Canada.
The connector must be compliant with NEMA 5-15.
120 V AC power supply
A flexible power cord approved to UL and with CSA label should be used. It should have the
following features: Type SJT with three leads, min. 18 AWG conductor cross-section, max.
length 4.5 m, parallel grounding plug 15 A, min. 125 V.
240 V AC power supply
A flexible power cord approved to UL and with CSA label should be used. It should have the
following features: Type SJT with three conductors, min. 18 AWG conductor cross-section,
max. length 4.5 m, and tandem grounded connector 15 A, min. 250 V.
Connecting
Steps for connecting the device to mains
1 Connect the IEC connector ①.
2 Connecting the power cord to the power
socket