Technical support
A.2 RAID system and device startup
SIMATIC IPC1047
Operating Instructions, 09/2018, A5E45118479-AA
117
A.2
RAID system and device startup
Problem
Possible cause
Possible remedy
The RAID software reports
the following errors:
•
The RAID plug-in failed
to load, because the
drive is not installed.
•
The Serial ATA plug-in
failed to load, because
the driver is not installed
correctly.
•
The Intel
®
Matrix
Storage Console was
unable to load a page
for the following reason:
–
A plug-in did not
provide a page for
the selected device
–
A plug-in failed to
load
RAID is not activated
The messages have no negative effect on the operation of the
device and can be ignored.
Acknowledge the messages.
After changing the drive, the
system does not boot from
the RAID system
RAID system does not have
highest boot priority
BIOS setup, Boot menu:
•
Permit RAID system in the boot priority
•
Set the RAID system to be first in the boot priority order.
After changing the drive,
"unused" is indicated for the
relevant SATA port
System was booted without
functioning drive. The
removable drive bay might
not be switched on.
Reboot the system with a functioning drive.
Computer does not boot or
"Boot device not found" is
displayed
•
The boot device is not
permitted
•
The boot device is not in
first place of the boot
priority in the BIOS
setup
•
The boot data carrier is
set up with GPT and
UEFI boot is deactivated
in the BIOS setup
•
In the BIOS setup "Boot" menu, permit the boot device in
the boot priority
•
In the BIOS setup "Boot" menu, change the boot priority of
the Boot device
•
Activate UEFI boot in the BIOS setup.
