Siemens SIMATIC Field PG P4, Руководство пользователя

Страница: 53 / 144

Configuring And Operating The SIMATIC Field PG P4
3-13
SIMATIC Field PG P4 Manual
A5E00180080-04
Connecting External Monitors
You must switch the PG off before you connect the monitor cable. You will find
further information about the connector pin assignment in Chapter 7.
VGA socket
Fig. 3-5 Connecting the Monitor
To connect the monitor, proceed as follows:
1. Switch off the SIMATIC Field PG P4 and the monitor.
2. Open the port cover on the rear of the device.
3. Plug the monitor cable into the VGA socket connector.
4. Secure the connector with the screws.
5. Plug the other end of the monitor cable into the monitor.
6. Switch on the SIMATIC Field PG P4 and the monitor.
7. Make the necessary changes in the SETUP program (Menu Main > Hardware
Options “CRT/LCD selection: Simultan. Auto”).
Note
Default setting is simultaneous operation of the flat screen display and of an external
monitor. The display unit is optimized for a format of 1024*768 pixels (XGA) or
1400 x 1050 pixels (SXGA+). Modes with lower resolution and text mode are
expanded to this format.
If you connect an external monitor with lower resolution than the display, the resolution
of the display is reduced to the resolution of the external monitor in simultaneous
operation.
You can optimize the external monitor display via BIOS Setup in the Main menu item
Hardware Options ”CRT/LCD selection: CRT only”.
You can use the program Panel “Field PG” to easily switch among the active display
devices.