Siemens SIMATIC ET 200S, Руководство пользователя

Страница: 427 / 652

Analog Electronic Modules
12-21
ET 200S Distributed I/O System
EWA-4NEB 780602402-12
12.2.2 Connecting Thermocouples
Introduction
This section contains additional information on connecting thermocouples.
Compensation of the Reference Junction Temperature
There are several ways in which you can measure the reference junction
temperature to obtain an absolute temperature value from the difference in
temperature between the reference junction and the measurement junction.
Table 12-25 Compensation of the Reference Junction Temperature
Option Explanation Reference junction
parameter
No compensation You obtain not only the temperature
of the measurement junction. The
temperature of the reference junction
(transition from copper line to
thermocouple line) influences the
thermal voltage. The measured
value is thus faulty.
No
Using a
compensation unit
in the input lines
of a single
thermocouple They are compensated via a
compensation unit. The
compensation unit is the transition
point of Cu wire to the thermocouple
cable. No additional processing by
the 2AI TC ST is required.
No
Use of a
resistance
thermometer
Pt100 climate
range to measure
the reference
junction
temperature
(practical method)
You can measure the reference
junction temperature using a
resistance thermometer (Pt100
climate range). With suitable
parameter settings, this temperature
value is distributed to the 2AI TC
Standard modules in the ET 200S
and is used to correct the measured
temperature value of the
measurement junction in the
modules.
Number of reference junctions: 1
The parameters of IM151-1
and of the 2AI TC must be
adapted:
•
2AI RTD Standard
configured to Pt100
climate range in the
correct slot;
•
2AI TC Standard:
Reference junction: RTD;
select reference junction
number 1
•
IM :
assignment of junction to a
slot with 2AI RTD
Standard; selection of a
channel;
Internal
compensation
with 2AI TC High
Feature A temperature sensor is installed in
the TM-E15S24-AT and
TM-E15C24-AT terminal modules.
The temperature sensor reports the
terminal temperature to the 2AI TC
High Feature. This value is
computed with the measured value
of the channel of the electronic
module.
•
2AI TC High Feature:
Reference junction: Yes