Siemens SIMATIC CC712, Руководство по эксплуатации

Страница: 42 / 112

Configuration
4.4 Calling the WBM
SIMATIC CC712
42
Operating Instructions, 05/2019, C79000-G8976-C503-01
Application to the runtime system
All saved configuration data is applied to the Runtime system by clicking on the "Apply"
symbol.
Incorrect entries in the configuration
The input boxes of the WBM are checked during input for faulty content and consistency.
Notes are output for boxes with detected errors during saving. The settings can only be
saved after the error has been corrected.
Grayed out fields cannot be edited.
4.4 Calling the WBM
4.4.1 Establishing a connection to the WBM
Requirements
You can establish a connection between a PC and the gateway via HTTPS:
You can establish a connection over the P2 interface of the gateway.
The condition for access to the gateway is that the PC is located in the same subnet and that
the gateway can be reached.
First connection setup with preset IPv4 address
Use the following preset IPv4 address of the gateway during the first connection setup:
● P2 interface address: 192.168.0.55
Note
IP address of the CP
By default, the DHCP client of the gateway is disabled. Make sure that the PC has a fixed IP
address during the first connection setup and that it is located in the same subnet as the
connected interface of the gateway.
When using a DHCP server you do not need to specify the addressing on the PC to be
connected. When it is connected to the network, the PC is assigned an address.