Siemens SIMATIC BATCH, Руководство по эксплуатации

Страница: 1118 / 1158

14.10.7 Abort step
Overview
With the “Abort step” command, you can abort a recipe step or a RUP/ROP before its planned
end.
● Abort recipe step
The recipe step is aborted regardless of whether the recipe step is running in continuous
operation or not.
The command executes only after a prompt for confirmation.
Note
You cannot continue an aborted recipe step.
● Abort RUP/ROP
A RUP/ROP is aborted before the planned end analogous to a batch.
You will find information on how to abort a batch before the planned end in the section
"Abort (Control menu) (Page 1065)“.
Additional information
Operator commands for recipe steps (Page 416)
14.10.8 Abort step (emergency)
Use this function to abort an active or held selected batch step even when there is no AS
connection.
Note
An aborted step cannot be resumed.
The sequence in this part of the recipe remains where it is until the start of the sequencer, e.g.
with the following transition.
14.10.9 Unlock step
With this function, you can unlock a batch element (RUP, ROP, RPH) that needs to be activated
in the batch control if the synchronization between SIMATIC BATCH and SIMATIC IT using
MES_SYNC_REQUEST is not working, for example because the SIMATIC IT connection is
down.
Additional information
Additional status identifier (Page 434)
Context help references
14.10 Shortcut menu commands
SIMATIC BATCH V8.2
1118
Operating Manual, 02/2016, A5E35958174-AA