Siemens SICAM CMIC, Руководство пользователя

Страница: 79 / 414

Preparing the Engineering
SICAM RTUs, User Manual SICAM CMIC
79
DC8-001-2.09, Edition 08.2016
3.7.2 SICAM WEB
Before SICAM CMIC can be parameterized via SICAM WEB, the following steps must be per-
formed:
•
Insert a suitable SD card with the current firmware codes into the target device (if not pre-
sent)
•
Switch on the target device
•
Set up physical connection with the target device
•
Establish communication with the target device
─
Set up IP configuration on the engineering PC
─
Set up dial-up connection on the engineering PC (if necessary)
─
Install security certificate on the engineering PC (if necessary)
─
Connect with the target device via web browser
3.7.2.1 Physical Connection with the Target Device
The following connection options are available:
•
Point-to-point connection via serial interface
•
Point-to-point connection via Ethernet interface
•
LAN/WAN connection via Ethernet interface
The access to the web server takes place via the IP address of the respective target device.
3.7.2.1.1 Point-to-Point Connection via Serial Interface
PC and target device are connected with a direct cable via the serial interface (DSUB9 con-
nector, male).
SIC AM C MIC
F4 F3 F2 F1
SIC AM C MIC
P O K
R Y
E R
E T H
L K 1
P K 1
R S -2 3 2
O H 2
R T X 2
R S -4 8 5
O H 3
R T X 3
E T H
L K 4
P K 4
S D
X4
SICAM CMIC
Direct cable connection
2xDB9F (TF5-204--)
Web browser