Configuration
3.1 System
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
97
Syntax
Call up the command with the following parameters:
lldp{transmit|receive}
The parameters have the following meaning:
Parameter
Description
Range of values / note
transmit
The sending of LLDP packets is ena-
bled.
Default: enabled
receive
The receipt of LLDP packets is ena-
bled.
Default: enabled
Note
Enabling both options
When you call this command, you can only select one option.
If you want to enable both options, call up the command again.
Result
Sending or receipt of LLDP packets is enabled.
Further notes
You disable the sending or receipt of LLDP packets with the
no lldp
command.
3.1.13.8
no lldp
Description
With this command, you disable the sending or receipt of LLDP packets on the interface.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
no lldp{transmit|receive}